Agilent Technologies 34401A - Manual (Page 110)

Remote Interface Reference
•
Command Summary, starting on page 105
•
Simplified Programming Overview, starting on page 112
•
The MEASure? and CONFigure Commands, starting on page 117
•
Measurement Configuration Commands, starting on page 121
•
Math Operation Commands, starting on page 124
•
Triggering, starting on page 127
•
Triggering Commands, starting on page 130
•
System-Related Commands, starting on page 132
•
The SCPI Status Model, starting on page 134
•
Status Reporting Commands, starting on page 144
•
Calibration Commands, on page 146
•
RS-232 Interface Configuration, starting on page 148
•
RS-232 Interface Commands, on page 153
•
An Introduction to the SCPI Language, starting on page 154
•
Output Data Formats, on page 159
•
Using Device Clear to Halt Measurements, on page 160
•
TALK ONLY for Printers, on page 160
•
To Set the GPIB Address, on page 161
•
To Select the Remote Interface, on page 162
•
To Set the Baud Rate, on page 163
•
To Set the Parity, on page 164
•
To Select the Programming Language, on page 165
•
Alternate Programming Language Compatibility, starting on page 166
•
SCPI Compliance Information, on page 168
•
IEEE-488 Compliance Information, on page 169
If you are a first-time user of the SCPI language, you may want to refer to these sections
to become familiar with the language before attempting to program the multimeter.
>
>
104