Kenwood KDC-X898 - Manual (Page 52)

52 |
KDC-X998/ KDC-BT958HD/ KDC-X898/ KDC-BT858U
Listen to the tuner (KDC-X898, KDC-BT858U)
11-5. Tuner setting
You can set up the tuner.
1
Press [SRC] and select a Tuner (“TUNER”)
source using [Control] knob.
Refer to
<Source selection> (page 14) .
2
Press [Control] knob.
Enters the Function setting mode.
3
Select “Settings” using [Control] knob.
For how to use [Control] knob, refer to
<3-3. How
to select the item> (page 13) .
4
Select a Tuner setting item using [Control]
knob.
Display Description
“Seek Mode” Sets the seek mode.
“ Auto1 ”: Automatic search for a station.
“Auto2”: Search in order of the stations in the preset
memory.
“Manual”: Normal manual tuning.
“Auto
Memory”
Memorizes 18 (FM) or 6 (AM) stations with good
reception automatically.
Refer to <11-3. Auto memory> (page 51) .
“MONO” [1] You can reduce the noise when stereo broadcasts are
received as monaural.
“ON” / “ OFF ”
“PTY
Search” [1]
Selects the Program Type and searches for a station.
Refer to <11-7. PTY (Program Type)> (page 53) .
“TI” [1] Switches to the traffic information automatically when
the traffic bulletin starts.
“ON” / “ OFF ”
( Colored text : Factory setting)
[1] Displayed only when FM broadcast is received.
5
Select a setting using [Control] knob.
Returns to the previous item.
Exiting from the Function setting mode
Press and hold [ 1/6].
11-6. Direct access tuning
(Function of remote control)
You can search for a station directly by entering
frequency.
1
Press [DIRECT] on the remote control.
“– – – –” appears and enter the Direct access tuning
mode.
2
Press the number buttons on the remote
control to enter the frequency.
Example:
Desired frequency Press the following buttons
92.1 MHz (FM) [9], [2], [1]
810 kHz (AM) [8], [1], [0]
3
Press [ENT] on the remote control.
Exiting from the Direct access tuning mode
Press [ 6] on the remote control.