Kenwood TS-590S - Manual (Page 14)

14
It is possible that the USB audio output
level from the TS-590S is too low. Try
adjusting Menu No. 65.
If there is a mistake in the ARUA-10
settings, audio reception sent by USB
audio to the computer is not played from
the computer speakers.
Refer to “4.3 ARUA-10 Settings” and
check the settings.
I cannot hear audio from the
transceiver over the computer
speakers.
The volume setting of the computer
speakers or headset may be too low. Try
adjusting the volume settings.
If the audio input route from the rear
terminal of the TS-590S is set to ACC2,
USB audio input received by the TS-590S
is not transmitted.
Refer to “4.1.1 Setting Up an Audio Input
Route from the Rear Terminal” and check
the settings.
When transmitting using the TS-590S
microphone PTT or “SEND” key, USB
audio received by the TS-590S is not
transmitted. When using the ARCP-590,
the “Transmission Controls Settings” are
required.
Refer to “4.2 Setting Transmission
Methods for Audio Input to the Rear
Terminal” and check the settings.
If there is a mistake in the ARUA-10
settings, USB audio input to the TS-590S
is not transmitted.
Refer to “4.3 ARUA-10 Settings” and
check the settings.
Operation Even though the transceiver is in
transmission mode, I cannot
transmit voice input from the
computer microphone.
If the computer microphone or headset is
muted, audio is not sent from the
computer.
Please check your computer’s sound
function settings.