Kenwood TS-590S - Manual (Page 9)

9
Using the [PF] keys, which set the DATA SEND functions, enables switching between
transmit and receive modes for audio input from the rear terminal.
4.2. Setting Transmission Methods for Audio Input to the Rear Terminal
The [SEND] keys on the PTT of the microphone connected to the TS-590S, and on the
TS-590S control panel, are the method for transmitting audio input to the microphone
connected to the TS-590S, so even if these operations are implemented, audio entered
as audio signals from USB cannot be transmitted.
To transmit audio input as audio signals from the USB, select one of the following
methods.
● Transmitting using the ARCP-590
With the ARCP-590, settings must be done to transmit audio input through the rear
terminal to use the on-screen [SEND] key.
Select "Setup TX control" from the ARCP-590 "Tool" menu. The "Setup TX control"
window is displayed.
In the window above, select "ACC2/USB" in the "Modulation line" setting, and then
select "USB".
For further details refer to the ARCP-590 help. (ARCP-590 details are downloadable
from the Kenwood website.)
● Use the ACC2 Connector’s PKS port to transmit.
This setting allows you to transmit audio received by the rear terminal by setting the
PKS port in the ACC2 Connector on the back of the TS-590S to “Low.”
For details of the connector and terminal specifications, refer to the TS-590S
instruction manual.
● Use the PF key assigned to the DATA SEND function to transmit.
By assigning the PF key to the DATA SEND function, the PF key can be used to
transmit audio received by the rear terminal
For details, refer to "4.1.7 Allocating DATA SEND Functions to PF Keys".