Kenwood TS-590S - Manual (Page 16)

16
Question Answer
The transceiver transmits, even
with no voice input from the
microphone, when the DATA
VOX function is set to ON.
Turning the DATA VOX to ON
causes the transceiver to
transmit, even when the
microphone is not connected.
The transceiver transmits
without my knowledge.
When the DATA VOX function is ON, for
laptop computers with internal
microphones, sounds near the computer
that are loud enough to trigger the VOX
are sent to the transceiver and
transmitted by VOX. Or sounds from
other software may be sent to the
transceiver and transmitted by VOX.
Please try the following.
・ Refer to “4.1.6 Data VOX Gain
Setting” and adjust the VOX Gain.
・ Use a headset.
・ While operating the transceiver, do
not use other software.
If the above methods do not work, turn
OFF the DATA VOX function.
Also, when the computer is left connected
to the transceiver using the USB cable,
sounds from other software, such as
alerts, music and video are transmitted to
the transceiver and sent by VOX
unintentionally.
If you leave the computer and
transceiver connected using a USB
cable please turn OFF the DATA VOX
before using your computer.
Reception quality depends on
the device.
Voice audio is affected by voice encoding
and the quality may differ from the original
voice reception quality. This is part of the
USB sound function specifications and is
unavoidable.
Operation
I can hear the beeping and voice
guidance audio from the
transceiver on the computer.
Alternatively, I want to be able to
hear them, but can't.
This can be configured in the transceiver
menu.
Please refer to “4.1.3 Mixed Beep
Settings to External Audio Outputs”.