Kenwood TK-3401DE - Manual (Page 12)

4
INSTALLING THE BELT CLIP
Do not use glue which is designed to prevent screw loosening when
installing the belt clip, as it may cause damage to the transceiver. Acrylic
ester, which is contained in these glues, may crack the transceiver’s back
panel.
Belt clip
If necessary, attach the belt clip using
the two supplied M3 x 8 mm screws.
Note:
◆ If the belt clip is not installed, its
mounting location may get hot during
continuous transmission or when left
sitting in a hot environment.
◆ The battery pack life is over when its operating time decreases even
though it is fully and correctly charged. Replace the battery pack.
◆ While operating the transceiver using a Li-ion battery pack in areas of
an ambient temperature of –10°C and lower, operating time may be
shortened.
BATTERY LIFE
The operating times listed in the table below are measured
under the following cyclic conditions:
Calculated using 5% transmit time, 5% receive time, and 90%
standby time.
Battery Type
Operating Time/ Hours (Approx.)
Digital Mode Analog Mode
Battery Saver
On
Battery Saver
Off
Battery Saver
On
Battery Saver
Off
KNB-45L
Supplied battery
16 H 14H 18H 14H
KNB-69L
Optional battery
22 H 18H 24H 18H