Kenwood DNX9240BT - Manual (Page 63)

English 63
Security Setup
You can set a security code to protect your
receiver system against theft.
⁄
• When the Security Code function is activated, the code
cannot be changed and the function cannot be released.
Note the Security Code can be set as the 4 digit number
of your choice.
Display the Security screen 1
Touch [ ] > [ ] > [System] > [Security].
(page 59)
Setup the SI (Security Indicator) 2
[Security Code Set] Displays the Security code
input screen.
[SI] Turns the SI function on or off.
If turned "ON", the SI indicator on the front
panel flashes when the vehicle ignition is off.
(
"ON")
Start Security Code setup 3
⁄
If you have already completed the code registration, •
[CLR] is displayed.
Enter a security Code 4
Input four-digit number.
Register your security code 5
Reenter the security code 6
Reenter the same security code as that you have
entered in Step 4 for confirmation.
⁄
If you enter a different security code, the screen •
returns to Step 4 (for the first code entry).
Register the security code again 7
Now, your security code is registered.
If you have pressed the Reset button or if you
have disconnected the Receiver from battery...
Enter the correct security code 1
You must enter the same security code as that
you have entered in Step 4.
Register your security code 2
Now, you can use your Receiver.
B64-4382-00_00_E_En.indd 63 B64-4382-00_00_E_En.indd 63 09.2.19 1:03:49 PM 09.2.19 1:03:49 PM