Videotec ULISSE MAXI NETCAM - Manual (Page 16)

EN - English - I
nstruc
tions manual
14
7.1.2 Assembling the camera and
motorised lenses
The correct device working, in the stated
temperature range, is guaranteed with the
use of camera and lens with temperature
from -10°C up to +60°C.
The customer has to take care of assembling the
camera and lenses.
7.1.2.1 How to open the housing
To open the housing, undo the screws on the sides
and lift the upper body.
Fig. 8
7.1.2.2 Fastening of the lens and camera to
the internal slide
It is necessary to isolate the body of the
camera from the attachment slide to avoid
interference on the Ethernet signal.
Maximum overall weight allowed for
camera and lens must not exceed 4.5kg
(10lb).
Connect the camera (02) to the lens (01).
Fasten the L-shaped small aluminium bracket (03) to
the camera by means of the nylon washer (04) and
the 1/4" screw (05).
01 02
03
04
05
Fig. 9
Position the lens on the slide (02) interposing the
plastic spacer (01), and fasten the whole assembly by
means of the nylon washer (03)and the 1/4" screw
(04).
If necessary, use the additional spacers to correctly
position the camera and lens.
01
02
03
04
Fig. 10
Fasten the aluminium plate (01) on the slide by
means of the M4 screws and relative washers (02).
02
01
Fig. 11
Fasten the small plates with the M4 screw (01).
01
Fig. 12