MagTek EC500 99875172 - Manual (Page 8)

8
1-3 Installation
1-3a CONNECTING THE PRINTER
>> Connection to the power supply
The printer must be connected to a properly protected and earthed electrical installation.
FI: Laite on liitettävä suojamaadoitus koskettimilla varustettuun pistorasiaan.
NO: Apparatet må tilkoples jordet stikkontakt.
SE: Apparaten skall anslutas till jordat uttag.
1. Connect the power cable to the power supply unit, then plug the power cable connector into the printer.
2. Next, plug the end of the power cable into an earthed power socket.
3. The printer is powered on, and the printer’s control panel lights up, indicating that the printer is working properly. If the control
panel does not light, then either installation has not been carried out correctly or the printer is not working properly. Check the
installation.
Before attempting any maintenance, ensure that the power cable is always unplugged. For your personal safety, ensure that
the cable and power supply unit remain easy to access, especially in the event of an emergency.
To save energy, the printer will automatically switch itself to standby mode after 10 minutes of inactivity.
>> Connecting the USB cable.
Under no circumstances should you connect the USB data cable before installation of the printer driver is complete.
Refer to the section on printer driver installation for further details, and follow the instructions carefully.