MagTek IntelliStripe 320 99875167 - Manual (Page 12)

IntelliStripe 320 Motorized Reader
4
EXTERNAL BEZEL LED
The External bezel LED is shown in Section 2, Figure 9. The LED can be set to red, green or
off. See IntelliStripe 320 Command Reference Manual, Part Number 99875168, for more
details.
FLASH UPGRADEABLE
The unit’s firmware is in-system Flash Upgradeable. This allows the unit’s firmware to be
upgraded in a field environment. This may be required in cases when new smartcard
specifications reach the marketplace.
SMARTCARD INTERFACE
The reader provides connections to all 8 ICC contacts as defined by ISO 7816 specifications.
The Reader supports ISO7816 T=0 and T=1 cards not requiring V
PP
, with a speed range of 9600
bps (baud per second) to 115200 bps. It also supports a variety of common memory card types.
See IntelliStripe 320 Command Reference Manual, Part Number 99875168, for more details.
ONBOARD SAM INTERFACE
The Reader provides a socket for one on board SAM. The SAMs comply to ISO 7816-3 (1997)
electrical requirements and do not require V
PP.
T=0 and T=1 are fully supported with a speed
range from 9600 bps to 115200 bps. See IntelliStripe 320 Command Reference Manual, Part
Number 99875168, for more details.
MAGNETIC STRIPE READER
The Reader can read up to three tracks of magnetic stripe card data. See IntelliStripe 320
Command Reference Manual, Part Number 99875168, for more details.
POWER FAILURE CARD EJECTION SYSTEM
The Reader has a power-failure card-ejection system. This system will automatically eject a card
when a power failure occurs. To enable this system, an optional external capacitor needs to be
connected to the reader. See Appendix A for more details.
FRONT GATE
The Front Card Gate prevents coins, dust, moisture, and debris, from entering the unit. The gate
resists opening except when ISO-size card enters the unit
Note
If the front-gate option is installed, the IntelliStripe 320 Reader
will be incapable of reliably reading mag-stripe cards during the