MagTek MICRImage CHECK READER - Manual (Page 17)

9
SECTION 3. OPERATION
This section contains check and card reading and cleaning procedures and LED indicator states.
CHECK READING PROCEDURE
1.
Orient the check so the MICR line is down and the printed side faces the center of the
MICRImage as indicated in Figure 3-1.
2.
Drop the check so the leading edge is in the open slot. Slide the check forward.
3.
When the MICRImage detects the presence of the check, the motor will turn on. At this
time gently urge the check forward until the unit grabs the check. When this happens,
release the check. The check will then be transported around the check path and will exit
through the other side.
4.
After the check is read, the MICRImage will transmit the data as specified by the
parameters.
5.
Remove the check.
Place Check Flush
Onto Entry Slot
Slowly Slide Check Forward
Until Reader Pulls Check In
1
2
Figure 3-1. Check Orientation - Insertion