Wagner ProCoat - Manual (Page 10)

English 10
4. Practice
Spraying
You will need:
• Scrap material / cardboard
Hold the Spray Gun Level
Practice on a piece of scrap material/cardboard
Tip:
Trigger gun after starting the
stroke. Release the trigger
before ending the stroke. The
spray gun should be moving
when the trigger is pulled and
released. Overlap each stroke
by about 30%. This will ensure
an even coating.
If the spray pattern becomes distorted or
stops completely while the gun is triggered,
follow any or all the procedures listed on
pages 12-14.
If you plan to be away from your spray
project for more than one hour, follow the
Short Term Storage instructions on page 15.
If you have difficulty achieving a good spray
pattern, your spray tip and gun filter may
not be ideal for the type of material you are
spraying. Refer to the chart below and on
page 75.
Spray
tip
Size
Filter
color
Spray
Material
Initial
Pressure
Setting
411
Red
Thin stains,
sealers
Minimum
511
413
Yellow
Thick latex
paints,
stains
Maximum
513
415
515
10” - 12”
(25 - 30 cm)
10” - 12”
(25 - 30 cm)
cORREct INcORREct