Clean the spray gun filter, 13 clean the spray gun filter, Safety – Wagner ProCoat User Manual
Page 13: Spraying troubleshooting, Clean the spray gun filter you will need
13
English
Safety
Spraying
troubleshooting -
clean the Spray
Gun Filter
You will need:
• Wrench
• Warm, soapy water for latex material
• Mineral spirits for oil based materials
• Replacement spray gun filter (if
necessary)
IMPoRtAnt: never clean the filter by
poking it with a sharp object.
1. Peform the Pressure Relief
Procedure, page 7.
5. Inspect the filter for
damage. Replace if any
holes or tears are found.
4. Remove the filter from the housing.
Clean with appropriate cleaning
solution (warm, soapy water for
latex materials; mineral spirits for
oil-based materials).
2. Pull trigger guard from filter
housing.
6. Replace cleaned filter, tapered end
first, into the gun housing.
note: It is important to place
tapered end first to ensure proper
sprayer operation.
3. Unscrew the filter housing using a
wrench.
7. Reassemble the spray gun.
PRIME
1
5
4
2
6
3
7