Campbell Scientific CR800 and CR850 Measurement and Control Systems - Manual (Page 250)

Section 7. Installation
250
'1 Minute Data Interval
Scan (1,Min,0,70)
Counter(4) = Counter(4) + 1
Battery (Batt_volt)
PanelTemp (PTemp,250)
TCDiff (Level,1,mV2_5,1,TypeT,PTemp,True ,0,250,1.0,0)
If TimeIntoInterval (0,1,Min) Then
TimeIntoTest = TimeIntoTest + 1
EndIf
'Call Output Tables
CallTable LogTable
NextScan
'2 Minute Data Interval
Scan (2,Min,0,200)
Counter(5) = Counter(5) + 1
Battery (Batt_volt)
PanelTemp (PTemp,250)
TCDiff (Level,1,mV2_5,1,TypeT,PTemp,True ,0,250,1.0,0)
If TimeIntoInterval (0,1,Min) Then
TimeIntoTest = TimeIntoTest + 1
EndIf
'Call Output Tables
CallTable LogTable
NextScan
'5 Minute Data Interval
Scan (5,Min,0,700)
Counter(6) = Counter(6) + 1
Battery (Batt_volt)
PanelTemp (PTemp,250)
TCDiff (Level,1,mV2_5,1,TypeT,PTemp,True ,0,250,1.0,0)
If TimeIntoInterval (0,1,Min) Then
TimeIntoTest = TimeIntoTest + 1
EndIf
'Call Output Tables
CallTable LogTable
NextScan