Campbell Scientific CR800 and CR850 Measurement and Control Systems - Manual (Page 344)

Section 8. Operation
344
Table 82. PakBus-LAN Example Datalogger-Communications Settings
Software→ Device Configuration Utility (DevConfig)
Tab→ Deployment
Sub-Tab→ Datalogger ComPort Settings Advanced
Setting→ PakBus Adr COM1 COM2 Is Router
Sub-Setting→ Baud Rate Neighbors
1 Baud Rate Neighbors
1
Datalogger ↓ Begin: End: Begin: End:
CR800_1 1 115.2K Fixed 2 2 115.2K Fixed 3 4 Yes
CR800_2 2 115.2K Fixed 1 1 Disabled No
CR800_3 3 115.2K Fixed 1 1 115.2K Fixed 4 4 Yes
CR800_4 4 115.2K Fixed 3 3 Disabled No
1
Setup can be simplified by setting all neighbor lists to Begin: 1 End: 4.
8.5.6.3 LoggerNet Setup
Figure 110: LoggerNet Network-Map Setup: COM port
In LoggerNet Setup, click Add Root and add a ComPort. Then Add a
PakBusPort, and (4) CR800 dataloggers to the device map as shown in figure
LoggerNet Device-Map Setup
(p. 344).