Campbell Scientific RDP500 Remote Data Platform - Manual (Page 13)

RDP500 Remote Data Platform
FIGURE 3.2-4. Properly installed internal enclosure.
Notice it is slightly shifted to the right.
6. Once the datalogger enclosure is firmly mounted, remove the load cell
from the top of the enclosure.
7. Route the load cell from the backside of the support structure and suspend
it from the upper hook with the U-bolt bracket facing up.
8. Using a flat blade screwdriver, turn the gain adjusting screw to move the
lower hook all the way inward—towards the fixed end of the
parallelogram (Figure 3.2-5).
9