Campbell Scientific RDP500 Remote Data Platform - Manual (Page 4)

RDP500 Remote Data Platform Table of Contents
ii
B.2.3 Send the CRBasic Program – Step 3 ......................................... B-2
B.2.4 Send the CD295/DataView II Configuration – Step 4 .............. B-2
B.3 Change Log ......................................................................................... B-3
C. Exchanging Internal Enclosure Mounting Bracket .C-1
C.1 Introduction ......................................................................................... C-1
C.2 Exchange Process................................................................................ C-1
Figures
3.1-1. Removal of the screws that hold on the pointer. ................................. 3
3.1-2. Releasing the tension spring................................................................ 3
3.1-3. Bolts that will be loosened to remove punch assembly and tape reel
assembly. ......................................................................................... 4
3.1-4. Adjustment of overload protection screw............................................ 4
3.1-5. Unscrewing zero adjustment knob. ..................................................... 5
3.1-6. Removal of helical spring.................................................................... 5
3.1-7. The parallelogram is stabilized with one hand while
the dashpot rod is unscrewed with the other.................................... 6
3.2-1. A gap of ~1/8” left under the bolt heads allows enclosure bracket to
slide under bolt head........................................................................ 7
3.2-2. Keyholes aligned over bolts. ............................................................... 7
3.2-3. Tightening bolts to attach enclosure to the base.................................. 8
3.2-4. Properly installed internal enclosure. .................................................. 9
3.2-5. Flat blade screwdriver turns the gain adjusting screw....................... 10
3.2-6. Side view showing cable and arms horizontal
and overload protection screw. ...................................................... 10
3.3-1. Solar panel cable and grounding wire routed through compression
fitting of rain gauge base. .............................................................. 12
3.3-2. Solar panel cable routed through compression fitting of internal
enclosure. ....................................................................................... 12
3.4-1. Calibration weights properly placed in the center of the basin. ........ 13
4-1. Default Campbell Scientific screen on a CR1000KD. ...................... 14
4-2. The Precip_in field displayed on a CR1000KD ................................ 15
4-3. The Initial Setup menu on the CR1000KD. ...................................... 15
4-4. The Cal Results table displayed on a CR1000KD............................. 16
5.1-1. PC200W Setup/Connect Tab............................................................. 18
5.2-1. DevConfig CR1000 Facility.............................................................. 19
5.2-2. DevConfig OS download window for CR1000. ............................... 20
5.2-3. Dialog Box Confirming a Successful OS Download ........................ 20