Arizona MAX-5000XL - Manual (Page 19)

AZI Customer Service 800-528-7411 or 602-470-1414 Page 19 of 92
4.5. Connecting a Computer
If you wish to monitor the test with a computer, connect a null
modem cable to the serial connector at the rear of the instrument.
Use any serial port communications program (not provided) on
your computer to read the reports transmitted from the MAX
5000XL serial port. The content of each message can be selected
from the REPORT SETUP menu which is described on page 51.

The MAX 5000XL is equipped with RS-232 serial
communications available at a 9-pin standard
serial communications socket at the rear of the
instrument. The standard communications
parameters used are 115.2 kbits/s, no parity,
eight data bits, and one stop bit. Refer to your
computer communications program manual for
instructions on configuring the computer to read
this data format.

The MAX 5000XL does not test to see if the computer is actually connected or
ready to receive data. It does not respond to a request from the computer for
status information.

The MAX 5000XL can send data to both the RS-232 serial port and the parallel
printer port at the same time. However, the graph that can be printed by the printer
is not in a format that can be received by the computer. Therefore, the graph will
not be sent to the RS-232 serial port.
If you have any questions about connecting a printer or computer to your MAX 5000XL,
call AZI Customer Service at 800-528-7411 or 602-470-1414.
4.6. Connecting the External Filter Kit
An optional External Filter Kit (AZI #Y990-0210) is available for the MAX 5000XL for use
in dusty environments. Installation is simple and requires only a Phillips screwdriver.
Remove the two indicated screws, position the filter and
secure by replacing the two screws. NOTE: the side of the filter with the two notches
faces up. See External Filter Cleaning on page 81 for filter cleaning instructions.
Remove
these two
screws
Position filter
and secure
with the same
screws.