Arizona MAX-5000XL - Manual (Page 32)

AZI Customer Service 800-528-7411 or 602-470-1414 Page 32 of 92
Result Display Options
 DISPLAY RESULT AS: Selects
the final display value of
moisture, solids or dry weight,
ash or LOI.
 % Moisture - Test results are
displayed as a percentage of
weight loss.
 % Solids - Test results are
displayed as a percentage of
weight remaining. The
instrument is optimized to run in %Solids for samples > 99.5% volatiles.
 % Dry Weight - Test results are displayed as a dry weight basis.
% Dry Weight = ((W
INITIAL
– W
FINAL
) / W
FINAL
) * 100
Note that the dry weight value ratio can exceed 100%, and often does in
applications such as soil and forest fuels analysis.
 % Ash – Test results are displayed as a percentage of weight remaining.
 % LOI – Test results are displayed as a percentage of weight loss.
 PASS-FAIL – Toggles ON or OFF
 Low Limit – sets the lowest
acceptable limit for the test.
A final test value below this
figure will cause a FAIL
indication to appear on the
display and, if selected in
setup, on printed reports.
 High Limit – sets the highest
acceptable limit for the
moisture test. A final test
value above this figure will
cause the FAIL indication to appear on the display and, if selected in setup,
on printed reports.
Low Moisture CF
 Low Moisture CF - For
extremely low moisture products,
a calibration factor can be used
to align MAX 5000XL results to
the reference standard. The
percentage difference between
the stabilized MAX 5000XL
mean values and the reference
standard is entered as the LOW
MOISTURE CF. This feature is
not typically used.