Actron Professional Enhanced Scan Tool 9640A - Manual (Page 93)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 7 – 5
Chrysler Diagnostics
7
RECORD DATA
The Record Data function records vehicle PID (Parameter Identification) data
while the vehicle is parked or being driven. This function is mainly used for diag-
nosing intermittent driveability problems that cannot be isolated by any other
method.
The tool records data based on time (5 frames prior to the start of the recording,
and for a duration after). The time after depends on the vehicle data rate.
The Record Data function allows diagnosis of an intermittent problem by ana-
lyzing data leading up to the problem, during the problem, and possibly after the
problem, depending on duration.
Select Record Data from the Chrysler
Functions list and press
ENTER
. Fol-
low all instructions on the display.
✓
The tool can maintain only one recording at a time. Be sure to thoroughly
review the old recording before erasing it.
If a recording currently exists in memory,
a message to Erase Old Recording is
displayed. The tool stores only one
recording at a time, so be sure review it
before erasing it.
✓
On 1999 and newer vehicles, a screen may ask you to select Engine Data
or Transmission Data.
Next, turn the ignition key On. Engine can be Off or Running.
Never operate the tool while driving. Have another person
assist with the operation of the tool.
Refer to “ Viewing Data ” on page 3-9 of
Using The Scan Tool for Entire and
Custom Data Lists.
On the next screen, select a triggering
method.
Manual Trigger allows the
technician to use the ENTER key. Trig-
ger On Codes automatically triggers
when a DTC is indicated by the vehicle.
Press ENTER and the scan tool estab-
lishes a communication link with the
vehicle.
Chrysler Functions |
4)View Data ]
` 5)Record Data [
6)Switch Test ~
Cannot Record. Old
Recording Filled Up
Memory. Erase Old?
~
! CAUTION
Select Record Data: |
` Entire Data List
Custom Data List
~
Pick Trigger Method
`1)Manual Trigger
2)Trigger On Codes
** INITIALIZING **
PRETRIG FRAME:-5
BACK To Exit ~