Actron Professional Enhanced Scan Tool 9640A - Manual (Page 94)

Chrysler Diagnostics
7 – 6 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
7
If Manual Trigger is selected, the scan
tool initializes by recording the first five
frames. When done, press
ENTER .
If Trigger On Codes was selected, then
the scan tool triggers when a DTC is
stored in the vehicle.
Press the BACK key twice to return to
the Chrysler Functions menu.
The scan tool recording time varies. A
recording consists of 5 frames of data
prior to the trigger and several frames
after the trigger. The amount of PIDs
recorded determine the number of
frames.
After a recording, the Scan Tool dis-
plays a prompt to playback the record-
ing. Answer NO to return to the
Chrysler Functions menu.
Answer YES to display recorded data.
SWITCH TEST
The Switch Test is used to test the operation of switches on various Chrysler
vehicle systems. These systems may include cruise control, A/C, braking, and
the shift lever position.
✓
Because of differences in vehicle designs, the Switch Test may not test
the same switches in every car.
Select Switch Test and press ENTER .
✓
Switches for the Engine and Transmission are combined into one list when
applicable.
Select a switch to be tested from the list
and press
ENTER
.
**Ready To Record**
Press ENTER Anytime
To Start Recording.
Stops Automatically ~
WaitingFor Trouble
Code To Trigger The
Start of Recording
BACK To Exit ~
**RecordingData*
FRAME: 14 of 29
Press ENTER to Stop ~
Playback Data?
<YES> NO ~
Chrysler Functions |
` 6)Switch Test ]
7)Actuator Test [
8)Idle Speed Test ~
Select SW To Test |
` A/C CLCH REL
ASD RELAY [
ASD VOLTS SENS ~