Samsung SC-D372-XAA - Manual (Page 96)

ENGLISH
92 92
IEEE 1394 Data Transfer
Recording with a DV Connection Cable
1. Set the [Power] switch to [PLAYER].
2. Set the [Mode] switch to [TAPE]. (SC-D375(H)/D975 only)
3. Connect the DV cable (not supplied) from the DV jack of the Camcorder
to the DV jack of the other DV device.
■ Make sure that is displayed.
4. Press the [Record Start/Stop] button to begin REC PAUSE mode.
■ <PAUSE> is displayed.
5. Start playback on the other DV device while you monitor the picture.
6. Press the [Record Start/Stop] button to start recording.
■ If you want to pause recording momentarily, press the [Record
Start/Stop] button again.
7. To stop recording, press the [ ■ (STOP)] button.
[ Notes ]
■ When you transmit data from the Camcorder to another DV device, some functions may not work. If this occurs, please
reconnect the DV cable or turn the power OFF and ON again.
■ When you transmit data from the Camcorder to PC, PC functions are not available in <M.Player> mode. Do not use
another DV device when using IEEE1394.
■ Do not connect the Camcorder to a PC using both DV and USB (SC-D375(H)/D975 only) cables. It may not operate
properly.
■ The IEEE1394 cable (DV cable) is sold separately.
■ Moving image software is commercially available.
■ Most DV enabled PCs have a 6 pin jack. In this case, a 6pin/4pin cable is required for the connection.
■ Most DV enabled Notebooks and Laptops have a 4 pin socket. Use a 4pin/4pin cable for the connection.
■ DIS and COLOR NITE features are not available when in DV (IEEE1394) mode. If DV (IEEE1394) mode is set, DIS
and COLOR NITE modes will be released.
■ Search (Forward/Reverse) is not available when in DV (IEEE1394) mode.
■ When using this Camcorder as a recorder, the pictures that appear on a monitor may seem uneven, however recorded
pictures will not be affected.
SC-D371/D372 SC-D375(H)/D975
œ œ
01227A SCD371 USA~098 2/1/07 9:40 AM Page 92