American Standard SELECTRONIC 6068.26X - Manual (Page 10)

FOR AC-VERSION
(MULTI HOOK-UP); Fig. 15, 15a
Unit #1
Unit #1
Unit #2 Unit #3
1 . Remove the COVER SCREWS (1) and COVER (2) from
each ELECTRICAL BOX (3).
2. See AC Version Electrical Hook-up for Unit #1 of the Multi
hook-up.
3. Install SENSOR WIRE GROMMET (4) and FLUSH VALVE
SENSOR WIRE (5) into the COVER (2) of each unit. Insert
the flush valve sensor wire connector into the CENTER
CIRCUIT BOARD RECEPTOR (6) on each unit. Fig. 15a.
4. Remove the SPLIT PLUG (7a) from the SENSOR WIRE
GROMMET (7) on the left side of each ELECTRICAL BOX (3).
5. Take the 10 ft. EXTENSION WIRE (8) from Unit #2 and
insert one end of the EXTENSION WIRE CONNECTOR (9)
through the SENSOR WIRE GROMMET (7) on left side of Unit
#1. Insert EXTENSION WIRE (8) into SPLIT PLUG (7a). Push
SPLIT PLUG (7a) into SENSOR WIRE GROMMET (7) to seal.
Insert EXTENSION WIRE CONNECTOR (9) into LOWER
CIRCUIT BOARD RECEPTOR (10). Fig. 15a.
6. Insert other end of EXTENSION WIRE (8) into SENSOR
WIRE GROMMET (7) on left side of Unit #2. Insert that
EXTENSION WIRE CONNECTOR (9) into the LOWER
CIRCUIT BOARD RECEPTOR (10) of Unit #2. Fig. 15b.
7. On Unit #2 ELECTRICAL BOX (3) remove ROUND
KNOCK-OUT (11) on the bottom of the box by pressing a
flathead screwdriver into the center of the ROUND
KNOCK-OUT (11). Fig 15b.
8. Insert additional SENSOR WIRE GROMMET (12) included
with Unit #2 into the knock-out opening in the bottom of the
ELECTRICAL BOX (3). Take the 10 FT. EXTENSION WIRE
(8) from Unit #3 and insert one end into the SENSOR WIRE
GROMMET (12) in the bottom of the ELECTRICAL BOX (3) of
Unit #2. Insert EXTENSION WIRE CONNECTOR (9a) into
TOP CIRCUIT BOARD RECEPTOR (13) on Unit #2 . Fig.
15b.
9. Insert the other end of the EXTENSION WIRE (8) from Unit #3
into the SENSOR WIRE GROMMET (7) on the left side of Unit
#3. Insert EXTENSION WIRE CONNECTOR (9) into LOWER
CIRCUIT BOARD RECEPTOR (10) on Unit #3.
10. Repeat Steps 7 to 9 as necessary for additional Multi-AC
Units.
11. Once all wire connections are made. Install the COVER (2)
and COVER SCREWS (1) onto each ELECTRICAL BOX (3).
Fig. 15
Fig. 15a
Fig. 15b
12
9
T O P T O P T O P
2
7a
7
8
3
6
1
5
4
9
T O P
10
SENSOR WIRE
CONNECTOR
SENSOR
WIRE
FROM UNIT #2
Unit #2
7a
7
8
3
9a
T O P
12
7
12
8
8
8 8
12
11
10
9
SENSOR WIRE
CONNECTOR
FROM
UNIT #3
BACK OF BOX (3)
FROM UNIT #1
REMOVE KNOCK-OUT (11),
INSERT WIRE GROMMET (12)
1
2
SENSOR
WIRE
SENSOR
WIRE
6
10
7
6
10
13
7
6
10
13
13
M968550 REV. 1.6