American Standard SELECTRONIC 6068.26X - Manual (Page 7)

11
6
1. Remove the four COVER SCREWS (1) and COVER
from (2) ELECTRICAL BOX (4). Fig. 10.
2. Pull the CIRCUIT BOARD (3) out from ELECTRICAL
BOX (4). Fig. 10.
3. Knock out lower blank in ELECTRICAL BOX (4) with
flat blade screwdriver. Install from the back of
ELECTRICAL BOX
(4) the POWER SUPPLY GROMMET
(8). Fig. 10a.
4. Attach the SAFETY CHAIN (5) from the FRONT
PANEL (6) to the MOUNTING POST (7) as shown.
Feed the Red and Black wires through the back opening
in the ELECTRICAL BOX (4). Fig. 10a.
5. From back of ELECTRICAL BOX (4) remove SPLIT
PLUG
(8a) from POWER SUPPLY GROMMET (8). Insert
POWER CORD CONNECTOR (9) through POWER
SUPPLY GROMMET (8). Insert POWER CORD (10) into
SPLIT PLUG (8a). Push SPLIT PLUG (8a) into POWER
SUPPLY GROMMET ( 8) to seal. Fig. 10b.
6. Insert POWER SUPPLY CONNECTOR (9) into
RECEPTOR
(11) on CIRCUIT BOARD (3). Install
CIRCUIT BOARD (3) into ELECTRICAL BOX (4).
Fig. 10b.
7. Install the SENSOR WIRE GROMMET (15) into the
COVER
(2) as shown. Remove the SPLIT PLUG (15a)
from SENSOR WIRE GROMMET (15). Insert SENSOR
WIRE CONNECTOR (12) through SENSOR WIRE
GROMMET (15). Insert SENSOR WIRE (13) into SPLIT
PLUG (15a). Push SPLIT PLUG (15a) into SENSOR
WIRE GROMMET (15) to seal. Fig. 10c.
8. Insert SENSOR WIRE CONNECTOR (12) into
CIRCUIT BOARD RECEPTOR
(14) slot. Fig. 10c.
9. Replace COVER (2). Tighten COVER SCREWS (1)
firmly.
CONNECT FRONT PANEL TO
ELECTRICAL BOX (AC POWER);
Fig. 10 7
Fig. 10
Fig. 10a
Fig. 10b
Fig. 10c
T O P
T O P
1
2
3
4
4
4
6 5
7
3
8
9
11
9
8
15
2
15a
1
12
13
8a
10
KNOCK OUT
BLANK
BLACK &
RED WIRES
14
T O P
8
T O P
7
M968550 REV. 1.6