Allied Telesis AT-S95 WEB User Manual
Page 155
Configuring Multicast Forwarding
Page 155
To define Multicast Groups:
1.
Click Multicast > Multicast Group. The Multicast Group Page opens:
Figure 102:Multicast Group Page
The Multicast Group Page contains the following fields:
•
Enable Bridge Multicast Filtering — Indicates if bridge Multicast filtering is enabled on the device.
The possible field values are:
–
Checked — Enables Multicast filtering on the device.
–
Unchecked — Disables Multicast filtering on the device. If Multicast filtering is disabled, Multicast frames
are flooded to all ports in the relevant VLAN. Disabled is the default value.
•
VLAN ID — Displays the VLAN for which Multicast parameters are displayed.
•
Bridge Multicast Address — Identifies the Multicast group MAC address/IP address.
•
Select the interfaces displayed in the table.
–
Ports of Unit — Specifies the port and stacking member for which the Multicast group settings are
displayed.
–
Trunk — Specifies the trunk for which the Multicast group settings are displayed.
•
Interface — Displays the currently defined interface.
•
Interface Status — Displays the current interface status. Available options are: excluded, forbidden, static
and dynamic.
2.
Check the Enable Bridge Multicast Filtering checkbox.