Allied Telesis AT-S95 WEB - Manual (Page 209)

System Utilities
Page 209
2. Select the After Reset image file.
3. Click Apply (below the table). The factory defaults are restored, and the device is updated. The device
reboots.
Defining TFTP File Uploads and Downloads
The File System Page contains parameters for system uploads and downloads and for copying firmware and
configuration files.
To define file upload and download settings:
1. Click Utilities > File System The File System Page opens:
Figure 146:File System Page
The TFTP File Uploads and Downloads section of the File System Page contains the following fields:
• Supported IP Format — Defines the supported Internet Protocol for TFTP operations. The possible field
values are:
– IPv4 — Indicates that IPv4 is supported.
– IPv6 — Indicates that IPv6 is supported.
• IPv6 Address Type — If IPv6 is selected as the Supported IP Format, indicates the supported Unicast
address type. The possible field values are:
– Link Local — Indicates that link local addressing is supported by the interface.
– Global — Indicates that global Unicast addressing is supported by the interface.