Allied Telesis AT-9448Ts/XP (Basic Layer 3) - Manual (Page 50)

Chapter 2: Installing the Switch
50
Twisted Pair and Fiber Optic Cable Specifications
Twisted Pair
Cable
Specifications
Table 9 lists the cabling specifications for the 10/100/1000Base-T twisted
pair ports.
Note
The auto-MDI/MDI-X feature on the twisted pair ports automatically
configures the MDI/MDI-X setting when a link is established with an
end node. Available when a port is at the default setting of Auto-
Negotiation, this feature allows you to use a straight-through twisted
pair cable when connecting any type of network device to a port.
Disabling Auto-Negotiation on a port and setting the speed and
duplex mode manually also disables the auto-MDI/MDI-X feature. A
port where Auto-Negotiation has been disabled defaults to MDI-X.
Disabling Auto-Negotiation may require manually configuring a
port’s MDI/MDI-X setting or using a crossover cable.
Table 9. Twisted Pair Cabling and Distances
Speed Cable Type
Maximum
Operating
Distance
10 Mbps Standard TIA/EIA 568-B-compliant
Category 3 or better shielded or
unshielded cabling with 100 ohm
impedance and a frequency of 16
MHz. 100 m (328 ft)
100 Mbps Standard TIA/EIA 568-A-compliant
Category 5 or TIA/EIA 568-B-
compliant Enhanced Category 5 (Cat
5e) shielded or unshielded cabling
with 100 ohm impedance and a
frequency of 100 MHz. 100 m (328 ft)
1000 Mbps Standard TIA/EIA 568-A-compliant
Category 5 or TIA/EIA 568-B-
compliant Enhanced Category 5 (Cat
5e) shielded or unshielded cabling
with 100 ohm impedance and a
frequency of 100 MHz. 100 m (328 ft)