Installing an xfp transceiver – Allied Telesis AT-9448Ts/XP (Basic Layer 3) User Manual
Page 59
AT-9400 Series Gigabit Ethernet Switches Installation Guide
59
Installing an XFP
Transceiver
To install an XFP transceiver in the AT-9424Ts/XP or AT-9448Ts/XP
Switch, perform the following procedure:
1. Remove the dust plug from a transceiver slot on the switch. Refer to
Figure 24. Removing an XFP Dust Plug
2. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
3. Position the transceiver with the label facing down.
4. Slide the transceiver into the slot until it clicks into place, as shown in
Figure 25.
Figure 25. Installing an XFP Transceiver
AT-944
8Ts/X
P
STAT
US
FAUL
T
MASTER
RPS
POWER
COMP
ACT FLASH
TERMINAL PO
RT
EJECT
49
50
47
45
CLAS
S 1
LASE
R PR
ODU
CT
L/A
XFP
XFP
LIN
K /
AC
T
STACK
PRES
L/A
L/A
48
46
1
2
MSTR
AT-944
8Ts/XP
STATUS
FAUL
T
MASTER
RPS
POW
ER
COM
PAC
T FLAS
H
TERMINAL PO
RT
EJECT
49
50
47
45
CLAS
S 1
LASE
R PR
ODU
CT
L/A
XFP
XFP
LIN
K /
AC
T
STAC
K
PRES
L/A
L/A
48
46
1
2
MST
R