Allied Telesis AT-S39 - Manual (Page 131)

AT-S39 Command Line Interface User’s Guide
131
SET SWITCH VLANMODE
Syntax
set switch vlanmode=userconfig|multiple|
dotqmultiple
Parameters
vlanmode Specifies the switch’s VLAN mode. Options are:
USERCONFIG Sets the switch to support port-
based and tagged VLANs. This is the
default.
MULTIPLE Configures the switch for the non-
801.Q compliant multiple VLANs
mode.
DOTQMULTIPLE Configures the switch for the 801.Q
compliant multiple VLANs mode.
The default is USERCONFIG.
Description
This command configures the switch’s VLAN Mode. The mode can be
user-configured, which supports port-based and tagged VLANs, or one
of two multiple VLAN modes.
Note
The switch can only support these VLAN modes when its mode is set
to tagged. To set the switch mode, refer to the SET SWITCH
SWITCHMODE command.
Example
The following command configures the switch to support 801.Q
compliant VLAN mode:
set switch vlanmode=dotqmultiple