Allied Telesis AT-S39 - Manual (Page 132)

Chapter 13: VLAN Commands
132
SET SWITCH VLANSTATUS
Syntax
set switch vlanstatus=enable|disable
Parameters
vlanstatus Specifies the switch’s mode. Specifying ENABLE
means the switch will support user-configured (port-
based and tagged) and multiple (801.Q compliant and
non-801.Q compliant) VLANs. Specifying DISABLE
means the switch will support the Basic switch mode.
The default is tagged and untagged VLANs. Only one
mode can be active on a switch at a time.
Description
This command configures a switch to support tagged VLAN switch
mode or the Basic switch mode.
Note
This command performs the same function as the SET SWITCH
SWITCHMODE command.
Example
The following command configures the switch to support the Basic
switch mode:
set switch vlanstatus=disable