Chapter 18, 1x port-based access control commands – Allied Telesis AT-S39 User Manual

Page 160

Advertising
background image

160

Chapter 18

802.1x Port-Based Access Control
Commands

❑ DISABLE PORTACCESS on page 161

❑ ENABLE PORTACCESS on page 162

❑ SET PORTACCESS on page 163

❑ SHOW PORTACCESS on page 166

Note

Remember to save your changes with the SAVE CONFIGURATION
command.

Note

You must use a local management session to configure port-based
access control. You cannot configure this feature through enhanced
stacking or from a Telnet management session.

Note

For background information on 802.1x port-based access control,
refer to the AT-S39 Management Software User’s Guide.

Advertising
See also other documents in the category Allied Telesis Computer hardware: