Allied Telesis AT-S60 - Manual (Page 118)

AT-S60 Management Software User’s Guide
Section II: Local and Telnet Management 117
Modifying a Port Trunk
Use this procedure to modify an existing port trunk. See the Port
Trunking Guidelines on page 111 for information specific to 10/100
Mbps and 1000 Mbps port trunks.
When you select the Modify Port Trunk selection on the Port Trunking
menu, you can perform the following actions:
❑ Changing the name of the trunk
❑ Adding ports to a trunk
❑ Deleting ports from a trunk
❑ Setting (or overwriting) the ports in a trunk
❑ Clearing (or removing) all the ports in a trunk
After you modify a port trunk, you need to return to the Main Menu and
save your changes using the S - Save Configuration Changes selection.
To modify a port trunk on the switch, perform the following procedure:
1. From the Main Menu, type 1 to select Port Menu.
The Port Menu is shown in Figure 25 on page 89.
2. From the Port Menu, type 4 to select Port Trunking.
The Trunk Configuration menu is shown in Figure 36 on page 114.
3. Type 3 - Modify Trunk to modify a port trunk.