Allied Telesis AT-S60 - Manual (Page 228)

AT-S60 Management Software User’s Guide
Section II: Local and Telnet Management 227
Configuring MSTP
This section contains the following procedures:
❑ Configuring MSTP Bridge Settings on page 227
❑ Configuring the CIST Priority on page 230
❑ Creating, Deleting, and Modifying MSTI IDs on page 231
❑ Associating VLANs to MSTI IDs on page 233
❑ Configuring MSTP Port Settings on page 236
❑ Displaying MSTP Port Settings and Status on page 238
Note
You cannot configure MSTP unless the protocol has been selected
as the active spanning tree protocol on the switch. For instructions,
refer to Enabling or Disabling STP, RSTP, or MSTP on page 196.
Configuring
MSTP Bridge
Settings
This section contains the procedure for configuring a bridge’s MSTP
settings.
1. From the Main Menu, type 3 to select Spanning Tree Menu.
The Spanning Tree Menu is shown in Figure 67 on page 196.
2. From the Spanning Tree Menu, type 5 to select MSTP Configuration.