Allied Telesis AT-S60 - Manual (Page 98)

AT-S60 Management Software User’s Guide
Section II: Local and Telnet Management 97
The possible settings for 9 - Duplex are:
Full - Indicates full-duplex mode
Half - Indicates half-duplex mode
Possible settings for A - MDI/MDIX Crossover are
MDI - Indicates the MDI setting
MDI/X - Indicates the MDI-X setting
Note
MDI/X applies only to copper ports, not fiber ports.
D - Set Default Port Configuration
Use this selection to reset the port parameters to their default
values. The port parameter defaults are illustrated in Figure 27 on
page 93.
5. After setting the port parameters, type R until you return to the Main
Menu. Then type S to select Save Configuration Changes.
Configuration changes are immediately activated on a port.
Table 2 Port-Duplex Settings on Line Cards
Line Card Port Duplex
AT-8411 TX Full and half
AT-8412/SC FX
AT-8412/MTFX Full only
AT-8413 GB/T
copper port Full only
AT-8413 GB/T
fiber port Full only
AT-8414/ST
AT-8414/SC Full and half