Allied Telesis AT-S60 - Manual (Page 508)

AT-S60 Management Software User’s Guide
Section IV: Web Browser Management 507
Configuring MSTP
This section contains the following procedures:
❑ Configuring MSTP Parameters on page 507
❑ Configuring the CIST Priority on page 510
❑ Creating, Deleting, or Modifying MSTI IDs on page 511
❑ Adding, Removing, or Modifying VLAN Associations to MSTIs
on page 513
❑ Configuring MSTP Port Parameters on page 515
Note
MSTP must be selected as the active spanning tree protocol on the
switch before you can configure it. For instructions on selecting the
active spanning tree, refer to Enabling STP, RSTP, or MSTP on page
496.
Note
When MSTP is enabled, the GVRP tab is not shown on the
Configuration or Monitoring Layer 2 page.
Configuring
MSTP
Parameters
To configure MSTP parameters, perform the following procedure:
1. From the Home Page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 155 on page 434.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected
by default, as shown in Figure 204 on page 541.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 183 on page 496.
4. Click Configure.
The expanded MSTP Spanning Tree tab is displayed as shown in
Figure 188.