Configuring a virtual bridge, To configure bridge parameters for an existing bri, Enter the vbridge/config/bridge <vlan#> command – Allied Telesis FORMULA 8200 User Manual

Page 43: Enter the desired information by entering the i, Enter 0 at the prompt to save changes and exit, Do not change any of the values unless you are ver, Configuring a virtual bridge -11

Advertising
Configuring a virtual bridge, To configure bridge parameters for an existing bri, Enter the vbridge/config/bridge <vlan#> command | Enter the desired information by entering the i, Enter 0 at the prompt to save changes and exit, Do not change any of the values unless you are ver, Configuring a virtual bridge -11 | Allied Telesis FORMULA 8200 User Manual | Page 43 / 164 Configuring a virtual bridge, To configure bridge parameters for an existing bri, Enter the vbridge/config/bridge <vlan#> command | Enter the desired information by entering the i, Enter 0 at the prompt to save changes and exit, Do not change any of the values unless you are ver, Configuring a virtual bridge -11 | Allied Telesis FORMULA 8200 User Manual | Page 43 / 164
Advertising
See also other documents in the category Allied Telesis Computer hardware: