Allied Telesis FORMULA 8200 - Manual (Page 111)

FORMULA 8200 User’s Guide
5-33
PORTSERV Command
Syntax
PORTSERV
PORTSERV/CONFIG/<subcommand>
PORTSERV/SHOW/<subcommand>
Menu
Description
The PORTSERV command applies to ATM functionality only. This
command allows you to configure and display port service for a
physical port. Table 5-10 describes the parameters in the display.
Refer to the AT-8202 ATM Uplink User’s Guide for more on ATM-
specific commands. The guide is available in PDF format from Allied
Telesyn’s website at www.alliedtelesyn.com/manuals.htm.
/ >portserv
/PORTSERV >
== PORTSERV MENU ==
[CONFIG] [SHOW]
Table 5-10 PORTSERV Command Parameters
Subcommand Alias Description
CONFIG CREATE cps Create a port service.
MOVE mvps Move a port service from one VLAN to another.
REMOVE rmps Remote a port service.
SHOW PHYPORT vpp Show the physical port configuration.
PORTSERV vps Show the port service configuration.