Allied Telesis FORMULA 8200 - Manual (Page 112)

Command Reference
5-34
REBOOT Command
Syntax
REBOOT
Menu
Description
The REBOOT command resets the FORMULA 8200. Its alias is reset .
It initializes the hardware, loads the system software from the flash,
and restores the switch to current configuration settings. Upon
restart, the POST and other diagnostic information appear, followed
by the login and password prompts.
/ reboot
Boot POST in progress...
PROM version: 1.0.7
Sizing DRAM (value displayed is bank size or error code)...
DRAM now configured into a contiguous block:
Address: ............. 0xa0000000 - 0xa07ffffc
Running DRAM test...
Initializing 4650 icache and dcache...
Initializing PIG chip...
Initializing PMIU chips...
PMIU_0 revision: ..... 0x0000000f
PMIU_1 revision: ..... 0x0000000f
PMIU_2 revision: ..... 0x0000000f
PMIU_3 revision: ..... 0x0000000f
Initializing PHY chips...
Initializing interrupt vectors in DRAM...
Running Extended DRAM test...
Boot POST complete, passing control to firmware...