Nikon D4S - Manual (Page 369)

347
U
Selecting Yes allows adjustments that are normally made by
holding the
I (Q), E, D, M, Y, S, T, U, or AF-mode
button and rotating a command dial to be made by rotating the
command dial after the button is released (this also applies to the
Fn
and Pv buttons and the Fn button for vertical shooting, if they
have been assigned Active D-Lighting using Custom Setting f3,
Assign Fn button;
0 337, Custom Setting f4, Assign preview
button; 0 342, or Custom Setting f7, Assign Fn button (vert.);
0 343). Setting ends when any of the affected buttons is pressed
again or the shutter-release button is pressed halfway. Except
when No limit is selected for Custom Setting c2 Standby timer,
setting will also end when the standby timer expires.
Selecting Enable release allows the shutter to be released when
no memory card is inserted, although no pictures will be recorded
(they will however be displayed in the monitor in demo mode). If
Release locked is selected, the shutter-release button is only
enabled when a memory card is inserted in the camera.
If ( W) is selected, the exposure indicators in the
top control panel and information display are displayed with
negative values on the left and positive values on the right. Select
( V) to display positive values on the left and
negative values on the right.
f11: Release Button to Use Dial
G button
➜ A Custom Settings menu
f12: Slot Empty Release Lock
G button
➜ A Custom Settings menu
f13: Reverse Indicators
G button
➜ A Custom Settings menu