Nikon S6200 - Manual (Page 32)

16
Th
e
Bas
ics of Shoo
ting and
Pl
ay
b
ack
Preparation 2 Charge the Battery
1
Prepare the included Charging AC Adapter EH-69P.
If a plug adapter* is included with your camera, attach the plug
adapter to the plug on the Charging AC Adapter. Push the plug
adapter firmly until it is securely held in place. Once the two are
connected, attempting to forcibly remove the plug adapter could
damage the product.
* The shape of the plug adapter varies according to the country or
region in which the camera was purchased.
The Charging AC Adapter comes with the plug adapter attached
in Argentina, Brazil, and Korea.
2
Make sure the battery is installed in the camera, and then connect the
camera to the Charging AC Adapter in order of 1 to 3.
• Keep the camera turned off.
• When connecting the cable, be sure that the camera connector is properly oriented.
Do not use force when connecting the cable to the camera. When disconnecting the
cable, do not pull the connector at an angle.
• The charge lamp slowly blinks green to indicate that the battery is charging.
• About 3 hours and 20 minutes are required to charge a fully exhausted battery.
• When the battery has been completely charged, the charge lamp turns off.
• See “The Charge Lamp” (
A 17) for more information.
3
Disconnect the Charging AC Adapter from the electrical outlet and
then disconnect the USB cable.
• When the camera is connected to an electrical outlet with the Charging AC Adapter,
the camera cannot be turned on.
USB Cable UC-E6 (included)
Charge lamp
Electrical outlet