elektraLite CP10xt Manual - Manual (Page 22)

19
SYSTEM PROGRAMMING
There are a number of features and settings for the CP10xt that are to be programmed during
installation that seldom if ever need to be set again. They are generally used by the installer to
customize the system to the particular installation. These are all accessed using the "Menu" switch.
Any menu selection that involves setting a value will be stored in battery backed memory.
Press "Menu" and the display will read:
MENU SELECT + -
AUDIO ON/OFF
Use the "+" and "-" keys to select from the different menu items. In the above display, audio enable
is the current selection. To select that item press "Enter". The display will go to the audio enable
menu where you can then set the audio enable to the desired value. You do not need to press "Enter"
once a menu item is programmed. You can press any other switch to continue. The various menu
items are explained in the following paragraphs.
Audio On/Off
The audio enable display reads:
AUDIO IS OFF
USE +/- TO SET
Use either the "+" or "-" key to toggle the audio on or off. When audio is on, chases will attempt to
sync to the beat of the audio signal. If there is no signal present the chase will not run. "AUD" will
appear in the chase display next to "BPM". Xfade is automatically set to 0 when a chase is controlled
by audio. The audio sensitivity can be adjusted from one of the following menu items.
Fixture Library
The fixture library display reads:
FIXTURE 01
GOLDENSCAN 2/3
Use the number keyswitches to select the fixture (01-16) then use the "+" and "-" keys to select from
the fixture library. You must set each of the 16 fixtures separately. This allows the CP10xt to patch its
faders and joystick to match the selected fixture type.
Chapter
7