elektraLite CP10xt Manual - Manual (Page 6)

3
CP10xt to control channels 1-8 and fixture 2 on the CP10xt to control channels 9-12. The fixture
library in the CP10xt accommodates these large fixtures with selections for upper and lower channel
blocks within the fixture.
Once selected you must then set the starting addresses of the CP10xt fixture numbers to align with
the DMX512 channels that are controlling the fixture. For example, if you are using fixture 1 to
control channels 1-6 on the moving light and fixture 2 to control channels 7-12, you must soft patch
the starting addresses of fixtures 1 and 2 to be 6 channels apart. If this moving light’s start address is
set to channel 1 then you would patch fixture 1 to channel 1 and fixture 2 to channel 7. Consult the
"System Programming" chapter for more information on soft patching.
AUDIO IN
Connect the audio input to a line level output from a mixing console or an audio preamp. Do not
connect this to a power amp or any speaker level source. Consult the chapter on chases as to how
this input is used.
MIDI IN/OUT
If you are using MIDI with the CP10xt, connect the MIDI out on the CP10xt to the MIDI in on
your computer interface, sequencer, or data storage device. Connect the MIDI out on the CP10xt to
the MIDI in on the other device. Read the chapter on MIDI for more information.