elektraLite CP10xt Manual - Manual (Page 25)

22
MIDI Memory Dump
The MIDI memory dump display reads:
PRESS GO TO SAVE
MEMORY VIA MIDI
Press "Go" to initiate a memory dump via the MIDI out port. This will encode and send a copy of
the cue, chase, macro and system parameter memory to a data storage device for backup or to
another CP10xt. While transmitting, "SENDING" will appear in the display. This takes several
minutes. The MIDI memory dump display will return when finished. Consult the MIDI chapter for
more information.
Memory Lock
This feature is hidden from the other system programming features in order to better protect the
memory. To access memory lock press "Enter", "Cue", "998", "Enter".
The memory lock display reads:
MEMORY LOCK OFF
USE +/- TO SET
Use the "+" or "-" key to turn memory lock on or off. With memory lock on, the cue, chase and
macro memory will be protected from accidental writes from the front panel. If anyone tries to store
a cue, chase or macro, the message "MEMORY LOCKED" will appear in the display.
Erase Memory
This feature is also hidden from the other system programming features. To erase the memory press
"Enter", "Cue", "999", "Enter".
The erase memory display reads:
"DELETE" 5 TIMES
TO ERASE MEMORY
Press "Delete" 5 times to erase all cue, chase and macro memory as well as setting all system
parameters to their factory settings. Use this feature with caution.
Control Lock
The front panel controls including all switches, faders and joystick can be disabled to protect an
installation from any tampering. To disable the controls, power up the CP10xt while holding the
“Delete” switch, to re-enable the controls, power up while holding the “Insert” switch.