Sony NWZ-X1051F - Manual (Page 159)

Troubleshooting
NWZ-X1050 / X1051 / X1060 / X1061 .GB.4-141-609-11(1)
1 1
Other
Symptom Cause/Remedy
The touch panel does not
work properly.
 A screen protection sheet or privacy filter is not applied
properly.
 If the sheet lies off the edge of the screen, or burrows its way
into the gap, reapply it. If you are using a sheet other than
Sony’s optional protection sheet, it may interfere with the
touch panel.
 The HOLD switch is set to the HOLD position.
 Slide the HOLD switch to the opposite position ( page
10).
There is no beep sound
when the player is
operated.
 “Beep Settings” is set to “Off.”
 Set “Beep Settings” to “On” ( page 119).
 The beep does not sound when the player is connected to the
optional cradle, or another device.
The player gets warm.  The player may become warm when the battery is being
charged and just after charging. The player also may get warm
when a large amount of data is transferred. This behavior is
normal and not cause for concern. Set the player aside for a
while to allow it to cool down.
The date and time have
been reset.
 If you left the player for a while with the battery used up, the
date and time may be reset. This is not a malfunction. Charge
the battery until appears on the screen ( page 24), and
set the date and time again ( page 26).
Noise is generated when
plugging or unplugging
the headphones.
 Take off the headphones when plugging or unplugging the
headphones. If you plug or unplug the headphones during
playing song or using Noise Canceling function, you may hear
a noise from the headphones. This is not a malfunction.
Table of
Cont
ents
Inde
x