Avaya P332G-ML - Manual (Page 81)

Chapter 11 Avaya P330 Layer 2 Features
Avaya P332G-ML User’s Guide 67
• The 802.1w standard defines differently the default path cost for a port
compared to STP (802.1d). In order to avoid network topology change when
migrating to RSTP, the STP path cost is preserved when changing the spanning
tree version to RSTP. You can use the default RSTP port cost by using the CLI
command set port spantree cost auto.
Spanning Tree Protocol CLI Commands
The following table contains a list of CLI commands for the Spanning Tree feature.
The rules of syntax and output examples are all set out in detail in the Reference
Guide.
Table 11.3 Spanning Tree Protocol CLI Commandss
In order to... Use the following command...
Enable/Disable the spanning tree
application for the switch set spantree
Set the bridge priority for spanning
tree set spantree priority
Set the RSTP bridge spanning tree
max-age parameter set spantree max-age
Set the RSTP bridge hello-time
parameter set spantree hello-time
Set the RSTP bridge forward-delay
time prameter set spantree forward-delay
Select between STP operation or
RSTP switch operation set spantree version
Display the bridge and per-port
spanning tree information show spantree
Set the TX hold count for the STA set spantree priority
Add a port to the spanning tree
application set port spantree enable
Remove a port from the spanning
tree application set port spantree disable
Set the port spantree priority level set port spantree priority
Set the cost of a port set port spantree cost