Sony CMT-M90DVD - Manual (Page 14)

14 GB
CMT-M90DVD 4-239-826-11(1) GB
5
To programme additional tracks, repeat
steps 3 and 4.
6
Press DVD N.
Other operations
To
Cancel Program
Play
Check the
program order
Add a track to
the end of the
program
Tips
• The program you made remains after Program Play
finishes. To play the same program again, press
DVD N. However, the program is cleared when
you open the disc tray.
• “---.--” appears when the total program time
exceeds 1000 minutes, or when DVD titles/chapters
are programmed.
Note
Depending on the DVD, you cannot use Program
Play.
Do this
Press PLAY MODE/TUNING
MODE in stop mode repeatedly
until both “SHUFFLE” and
“PGM” disappear.
Press DVD . or > on the
remote repeatedly during Program
Play.
Perform steps 3 and 4 in stop
mode.
Creating your own
program
— Program Play
You can make a program of up to 25 steps.
Using the front panel display
1
Press FUNCTION repeatedly to switch
the function to DVD.
2
Press PLAY MODE/TUNING MODE in
stop mode repeatedly until “PGM”
appears.
3
Press DVD . or > on the remote
repeatedly until the desired title or
track number appears.
When programming a DVD, press ENTER/
YES on the remote, then press DVD .
or > on the remote repeatedly until the
desired chapter number appears.
4
Press ENTER/YES on the remote.
The title/chapter, or track is programmed.
The step number appears, followed by the
last programmed title or track number.
If you made a mistake, you can clear the last
step from the program by pressing CLEAR
on the remote.
Selected title or track number
Last programmed title
or track number
Total playing time
DVD
TITLE PGM
SEC MIN
DVD
TITLE PGM