Sony DCR-IP210 - Manual (Page 151)

151
Viewing Images Using your Computer
There are the following ways of connecting your camcorder to a computer in order to
view images saved on a “Memory Stick” or recorded on a tape on your computer.
To view images on a computer which has a Memory Stick slot, first remove the
“Memory Stick” from your camcorder and then insert it into the computer’s Memory
Stick slot.
* When connecting to a computer without a USB jack
Use an optional floppy disk adaptor for Memory Sticks or a PC card adaptor for
Memory Sticks.
When purchasing an accessory, check its catalog beforehand for the recommended
operating environment.
When connecting to a computer, complete installation of the i.LINK driver, the
USB driver or the application softwares before connecting your camcorder to
the computer. If you connect your camcorder to your computer first, you will
not be able to install the i.LINK driver or the USB driver correctly.
For details about your computer’s connectors and editing software, contact the
computer manufacturer.
— Viewing Images Using your Computer —
Viewing images on your computer
– Introduction
Tape image
Connection
cable
Computer
environment
requirements
Reference pages
For
Windows
users
For
Macintosh
users
Camcorder
Connection
jack
“Memory
Stick” image
USB cable
(supplied)
i.LINK cable
(optional)
USB cable
(supplied)
USB connector,
editing software
i.LINK (IEEE
1394), connector
editing software
USB connector,
editing software
172 – 174
154 – 156
158 – 159
164– 168
153
154 – 157
160
169 – 171
USB jack
i.LINK
(MICROMV
Interface)
USB jack*