Sony DCR-IP210 - Manual (Page 18)

18
Charging the battery pack
Charge the battery pack before using your camcorder.
Your camcorder operates only with the “InfoLITHIUM” battery pack (NP-FF70).
See page 196 for details of the “InfoLITHIUM” battery pack.
(1) Open the jack cover and connect the supplied AC power adaptor to the DC IN
jack on your camcorder with the plug’s v mark facing down.
(2) Connect the power cord to the AC power adaptor.
(3) Connect the power cord to a wall outlet.
(4) Set the POWER switch to (CHG) OFF.
The battery CHG lamp lights up when the charge begins. After charging is
completed, the battery CHG lamp goes off (full charge).
After charging the battery pack
Disconnect the AC power adaptor from the DC IN jack on your camcorder.
Step 1 Preparing the power supply
2
3
1
4
MEMOR
Y/NETW
ORK
CAMERA
POWER
(CHG)
OFF
ON
MODE
VCR
Battery CHG lamp
To a wall outlet