Sony DCR-IP210 - Manual (Page 186)

186
If you run into any problem using your camcorder, use the following table to
troubleshoot the problem. If the problem persists, disconnect the power source and
contact your Sony dealer. If “C:ss:ss” appears on the LCD screen, the self-diagnosis
display function has activated. See page 192.
In the recording mode
Symptom Cause and/or Corrective Actions
• The POWER switch is not set to CAMERA.
c Set it to CAMERA (p. 29).
• The tape has run out.
c Rewind the tape or insert a new one (p. 25, 42).
• The write-protect tab is set to expose the red mark.
c Use a new cassette or slide the tab (p. 25).
• The tape is stuck to the drum (moisture condensation).
c Remove the cassette and leave your camcorder for at
least one hour to acclimatize (p. 201).
• When your camcorder is in the recording standby mode
for more than five minutes, your camcorder automatically
turns off to save battery power and to prevent battery and
tape wear.
c Set the POWER switch to (CHG) OFF and then to
CAMERA.
• The battery pack is dead or nearly dead.
c Insert a fully charged battery pack (p. 17, 18).
• The viewfinder lens is not adjusted correctly.
c Adjust the viewfinder lens (p. 32).
• STEADYSHOT is set to OFF in the menu settings.
c Set it to ON in the menu settings (p. 179).
• The setting is the manual focus mode.
c Set FOCUS to AUTO (p. 67).
• Shooting conditions are not suitable for autofocus.
c Adjust to focus manually (p. 67).
• The LCD panel is open.
c Close the LCD panel when you record using the
viewfinder (p. 9).
• The contrast between the subject and background is too
high. This is not a malfunction.
• This is not a malfunction.
• SLOW SHUTTER, Super NightShot or Color Slow Shutter
mode is activated. This is not a malfunction.
START/STOP does not operate.
The power goes off.
The image on the viewfinder screen
is not clear.
The SteadyShot function does not
work.
The autofocusing function does not
work.
The picture does not appear in the
viewfinder.
A vertical band appears when you
shoot a subject such as lights or a
candle flame against a dark
background.
A vertical band appears when you
shoot a very bright subject.
Some tiny white, red, blue or green
spots appear on the LCD screen.
— Troubleshooting —
Types of trouble and how to correct
trouble