Sony DCR-IP210 - Manual (Page 43)

43
Playback – Basics
To display the screen indicators – Display function
Press DISPLAY/TOUCH PANEL on your camcorder or DISPLAY on the Remote
Commander. The indicators disappear on the LCD screen.
To make the indicators appear, press DISPLAY/TOUCH PANEL or DISPLAY again.
Using the data code function
Your camcorder automatically records not only images on the tape but also the
recording data (date/time or various settings when recorded) (data code).
Follow the steps below to display the data code using the touch panel or the Remote
Commander.
Using the touch panel
(1) In the playback mode, press FN and go to PAGE3.
(2) Press DATA CODE.
(3) Select CAM DATA or DATE DATA, then press OK.
(4) Press EXIT.
Using the Remote Commander
Press DATA CODE on the Remote Commander in the playback mode.
The display changes as follows:
date/time
t various settings (SteadyShot off, exposure, white balance, gain, shutter
speed, aperture value) t no indicator
To not display various settings
Set DATA CODE in
to DATE in the menu settings (p. 185).
The display changes as follows when you press DATA CODE on the Remote
Commander:
date/time
y no indicator
[a] SteadyShot off
[b] Exposure mode
[c] White balance
[d] Gain
[e] Shutter speed
[f] Aperture value
Playing back a tape
DATA CODE
CAM
DATA DATE
DATA
OFF OK
Date/time
NOV 15 2002
12:05:56 PM
50min 0:00:23
60 AWB
F1.8 9dB
AUTO
50min 0:00:23
[a]
[b]
[c]
[d]
[e]
[f]
Various settings